The HTD6 servo lifting column is a multi-stage electric lifting system. The configuration described here uses 220 V AC input and reaches up to 10 meters when fully extended. It also combines a wireless remote, a Xinjie touch screen, and a manual crank interface.
HTD6 configuration summary
- 220 V AC power input
- Up to 10 meters total extended height in the described configuration
- Industrial wireless remote control
- Xinjie touch screen for height and speed settings
- Manual crank interface for defined backup procedures
These items describe a system configuration. They do not prove suitability for every site. Confirm the exact order scope, load, wind case, base, controls, and safety functions.
Power and control integration
The 220 V AC input can fit sites that already provide mains power. The installation still needs the correct breaker, isolation, grounding, cable protection, and local electrical approval.
The touch screen can set motion commands when supported by the supplied controller. The wireless remote allows operation away from the column. Radio range depends on obstacles, interference, antenna position, and site conditions.
Manual backup operation
The manual crank interface is a backup feature. It is not a substitute for safe electrical design. Before manual movement, isolate power and control the load under the approved procedure.
Selection checklist
- Required extended and retracted height
- Payload mass and center-of-gravity offset
- Indoor or outdoor use, including wind load
- Speed, stops per cycle, and duty cycle
- Base size, anchors, floor strength, and tip-over margin
- Control method, limits, feedback, and emergency behavior
Product parameter selection example
Assume a sensor package has a mass of 35 kg and sits 200 mm from the column center. The target height is 8 meters. The column will move six times per hour indoors.
Calculate the force and offset moment first. Then check stage overlap, deflection, speed, brake behavior, and base stability. If the unit may be used outdoors, add the approved wind-load case.
This example is not a product approval. The final configuration needs the real payload, base, anchors, motion profile, and environment.
Typical uses
- Camera, lighting, and sensor elevation
- Indoor test and demonstration systems
- Communication and monitoring equipment
- Custom industrial platforms with long vertical travel
See more electric lifting column options. For a technical review, provide the height, load, offset, base, duty cycle, controls, and environment.
Frequently asked questions
The configuration described on this page uses 220 V AC input. Confirm the supplied voltage and site electrical rules before use.
The described multi-stage configuration has a total extended height of up to 10 meters. Confirm payload, wind, base stability, and the exact supplied geometry.
The described control package includes an industrial wireless remote and a Xinjie touch screen. Actual scope depends on the order.
It provides a backup movement method for defined service or recovery cases. Use it only under the approved isolation and manual-operation procedure.