HTS7 Wireless

General Features

  • Type: Wireless
  • IP grade: IPX4
  • Drive motors: 1-6 motors
  • Operation: Synchronous
HTS7 Wireless

HTS7 is a wireless controls, adopts wireless radio frequency technology, featuring a long transmission distance, non-directionality, high transmission sensitivity, and no signal blockage. The shell is made of imported high-quality ABS flame-retardant materials, ensuring safe and reliable use.

General Features

  1. Operating Voltage: 12VDC
  2. Operating Current: ≤30mA
  3. Operating Frequency: 433MHz
  4. Transmission Power: ＞15mW
  5. Transmission Distance: ≤200m [subject to actual measurement]
  6. Frequency Deviation: ±0.2MHz
  7. Transmission Rate: 3-6K
  8. Encoding Chip: EV1527
  9. Battery Model: 12V23A
  10. Matching with GEMING control box HTT- series.

HTS7 Wireless

View

setTimeout(() => { let backupModels = document.querySelectorAll(‘.bp3d_backup_view’); if (backupModels.length > 0) { backupModels.forEach(element => { if (element) { element.style.display = ‘block’; setTimeout(() => { let adminMessages = document.querySelectorAll(‘.bp3d_admin_message’); if (adminMessages.length > 0) { adminMessages.forEach(adminMessage => { if (adminMessage) { adminMessage.style.display = ‘block’; } }); } }, 5000); } }); } }, 5000);
Operating instructions for HTS7 Remote Control Handset
  1. Press(stop button)for 10 seconds before use, and then”lift normally”.
  2. Stroke reset:

    In case that the push rod does not work or is garbled when it is in the alarm state or after runing to the lowest position,

    Press the ‘stop’ button for 10 seconds, release the button after returning, and the push rod starts to retract to the end.

    And rebound to a certain height, then the lowest height is displayed after reset. complete.

  3. Coding instructionAfter the power supply is plugged into the 220V power supply, press the up key △ and you will hear the buzzer from the controller,

    Then press Stop key □ and listen to the buzzer of the controller,Then press Down key ▽ and listen to the buzzer of the controller,

    Complete code alignment, can be used directly.

Time-Proven Application

Installed in a woodworking saw table in 2017,
this linear actuator remained in continuous service for years without replacement.

In 2025, the same customer reordered the identical model for a new project.

See Time-Proven Application